Skip to main content

Certified PROFIBUS System Designer - Manchester UK (3 days)

Peter Thomas,
  • 06.02.2018
  • 13.03.2018
  • 11.09.2018
  • 30.10.2018

Certified PROFIBUS System Designer - Good quality PROFIBUS training has been widely available for installers, maintenance technicians and engineers for many years. Unfortunately, key decision makers – managers, system designers and system integrators are quite often less well trained than others who are involved in the engineering. Many of the mistakes that can be seen in installations are traceable to fundamental decisions that were taken at the early stages of the project. For example, use of inappropriate technology for an application, lack of awareness of maintenance and fault-finding facilities, over-complex or inappropriate system architecture, design decisions based on equipment purchasing cost rather than whole life-cycle costs etc. The PI-approved learning outcomes for this course are available for downloading in the link below.

Note - This is an instructor-led classroom based training course and that the Certified PROFIBUS Installer certificate is a pre-requisite for this course.

19/01/2018LO-CPSD_4742_V10_Jul15.pdfpdf2 MB
 Back to list

Our well-known PI technologies

PROFIBUS is a standardized, open, digital communications system for all areas of application in manufacturing and process automation.

PROFINET is the innovative open standard for Industrial Ethernet. It satisfies all requirements of automation technology.

IO-LINK is an independent sensor / actuator interface solution for use with with all automation technologies.