The 'Certified PROFIBUS Engineer' course is a world wide recognized training program. It's standardized by PROFIBUS International to create a quality platform for PROFIBUS qualified persons who are acknowledged by an official exam. (On site course also available)
The Certified PROFIBUS Engineer course is an intensive hands-on and theoretical 4-day training program. On the last day there will be an exam. After passing the exam, the participant gets the title ‘Certified Engineer' and will be officially registered. The registration is valid for 3 years. Extension is granted after a fresh up course.
The Certified PA module takes 2½ days (including the exam) and is fully concentrated on PROFIBUS PA. It is only accessible for people who have passed the standard Certified PROFIBUS Engineer course.
PROFIBUS plays a primary part in industrial automation and in most cases Certified Engineers are the only ones who can carry out the project. Through the valuable Certified Engineer status, companies and its employees can distinguish themselves from the other companies who are involved with this technology.
Certified PROFIBUS Engineer (CPE)
• Basics
• The technology of RS 485
• Network components
• Test and measurement equipment
• Bus parameters and cycle times
• The technology of DP
• Practical exercises
• More
Certified PA Module (CPA)
• Difference between DP and PA DP-V1
• Available DP/PA couplers and links
• The technology of MBP
• Network components
• Explosion safety and solutions
• Parameters and profiles
• Practical exercises
• More
More information
Contact us via southeastasia@profibus.com
Who should attend?
This course is intended for everyone who has to understand
the theoretical and practical aspects of PROFIBUS.
Prerequisites
There are no prerequisites for joining the course, however it's recommended that the attendee has knowledge about the following:
• Terms which are common in the industrial automation (PLC, remote I/O, etc.).
• Terms which are common in electrical engineering (resistance, voltage, etc.).
• Familiar with Binary and Hexadecimal representations.
• Capable of working with at least Windows 98.